ctrld opened the WFP engine with a plain FWPM_SESSION0, so every filter and
sublayer it installed was persistent for the engine's boot lifetime: the kernel
kept enforcing them after the installing process was gone. Any exit that did
not run the shutdown path - kill, crash, or a service stop during upgrade -
left them behind.
In hard intercept mode that orphaned the DNS block filters. With Firewall Mode
enabled it orphaned machine-wide block-all filters that carry no process or SID
condition, so the entire host lost outbound traffic: browsers, other users, and
a replacement ctrld's own API bootstrap alike, with no way back short of a
reboot.
Set FWPM_SESSION_FLAG_DYNAMIC on both engine sessions (hard intercept and
loopback protect). Windows then deletes everything the session owns when the
handle closes, including on abnormal termination, so ctrld's enforcement can no
longer outlive the process that installed it.
This removes the cause. The next commit adds startup self-heal for hosts
already carrying orphaned filters from a build that predates this change.
macOS Firewall Mode blocked forwarded/NATed VM/container egress: a guest
resolves DNS through a path host ctrld does not observe, so the guest-resolved
public IP never enters <ctrld_allowed> and the blanket outbound block drops the
guest's TCP/443.
Make VM/container guests first-class Firewall Mode clients by forcing their DNS
through ctrld. The trusted source subnets are the UNION of:
- Auto-detected VM/NAT networks (default, no config): interfaces that are up,
carry an RFC1918 IPv4 address, and whose VM ownership can be proven either
by a vendor-specific name (vnic/vboxnet/vmnet) or by being a bridge* whose
member list contains a vendor VM interface (typically vmenet*). Each keeps
its ingress interface, and its pf rules are scoped "on <iface>" so an
unrelated interface on the same private range is never affected.
- service.firewall_forwarded_sources (opt-in): explicit IPv4 CIDRs, matched on
the source CIDR alone, for stacks whose ownership cannot be proven. Config
adds only; an invalid or non-IPv4 entry is dropped with a warning.
Checking bridge membership is what makes the common case work without config.
Every vmnet.framework stack - UTM and other Virtualization.framework guests,
Docker Desktop, Multipass, Fusion 12.1+ NAT - puts the RFC1918 gateway address
on a bridge10x interface and attaches the vendor-named vmenet* interface as an
address-less member, so matching on interface name alone never sees them.
Membership is the ownership proof a bridge name lacks: macOS shares that
namespace with Thunderbolt/aggregated links (ctrld's own tunnel-change code
treats bridge0 as physical), and such a bridge has en* members, so it stays
untrusted however private its address. Members are read with ifconfig, and only
for a bridge that already carries an RFC1918 IPv4 address, so a host with no VM
running executes no subprocess.
Per source subnet, plaintext DNS (53) is force-routed through ctrld (route-to
lo0 -> existing rdr-on-lo0) so guest resolutions are policy-enforced and
populate the allowlist; guest egress to allowed IPs is then permitted by the
existing <ctrld_allowed> rule. DoT (853) is blocked so guests cannot swap in an
alternate resolver. DoH/443 is a documented limitation.
Rules are emitted strictly per address family. Sources are IPv4 (interception
targets ctrld's IPv4 listener), so only inet rules are generated: pf rejects an
entire anchor over a single "inet6 ... from 192.168.x.0/24" mismatch, which
would take DNS interception down with it. Guest IPv6 DoT is covered by the
blanket IPv6 block instead, since such a resolver never enters <ctrld_allowed>.
firewall_forwarded_sources is deliberately not validated with `cidr`. Entries
are checked where they are parsed and a bad one is dropped while the rest of the
set still applies. A hard validator would make one typo in an MDM-pushed subnet
fatal at startup - validateConfig exits the process - taking DNS service down
for the whole host over a line that only ever widened a firewall allowance. The
warning fires when the set of unusable entries changes rather than on every
parse, since config is re-read on every anchor build and every watchdog tick.
Reconcile the trust set at runtime, since VM interfaces appear and disappear
while ctrld runs and no existing path rebuilds an intact anchor for that
(ensurePFAnchorActive returns early, checkTunnelInterfaceChanges tracks only
tunnels, pfInterceptMonitor rebuilds only after a failed host probe). On a
change, rebuild the anchor and drop the pf states of the affected subnets
(targeted pfctl -k, not a global state flush), because rules govern only new
states: a stopped guest would otherwise keep using states created while it was
trusted, and a newly trusted one would keep bypassing interception until its
states expired. Reconciliation runs on interface appear/disappear, on network
changes, on the delayed post-change re-checks (a VM network often gets its
address after its interface appears), and on the pf watchdog tick, which bounds
guest start/stop convergence to one interval even with no network event.
Convergence is not latched on failure: the applied set advances, and states are
killed, only after pf has accepted the new anchor. reloadForwardedSourceAnchor
reports write/pfctl failures to the caller, which then keeps the previous set
recorded and logs a warning, so the next reconcile retries the same transition
instead of going quiet with the old anchor still installed. The whole
compare-reload-record sequence is serialized so a watchdog tick and a network
change cannot both rebuild or interleave snapshots.
Every anchor rebuild records the forwarded-source set it installed, and takes
that set as a parameter rather than re-detecting internally. Otherwise a rebuild
triggered by something else (tunnel change, watchdog restore, VPN DNS
exemptions, forced reload, startup) leaves the snapshot at the older set and the
next reconcile "discovers" the same change again: another rebuild, another round
of killed guest states, and a transition logged for something already in effect.
Passing the set in also means what pf loaded is exactly what gets recorded, so
an interface appearing mid-reconcile cannot leave the snapshot describing a set
that was never installed.
The anchor file is replaced atomically (temp file plus rename). Seven paths
rebuild it from timers and network-change callbacks in their own goroutines with
no lock between them, and os.WriteFile truncates before writing, so a pfctl -f
racing that window could read a partial ruleset and reject the anchor - taking
DNS interception down until the next watchdog restore.
Report the effective trust set at startup and on every change, naming each
subnet's origin ("192.168.64.0/24 (configured)" vs "(auto-detected on
bridge100)"), and say so explicitly when the set is empty, including what
auto-detection requires. Configured entries previously produced no log output at
all, so an admin who set firewall_forwarded_sources could not confirm it had
taken effect without reading pf rules. Per-source detection logging is at debug,
since detection re-runs on every anchor build.
Explicit, per-subnet trust boundary (RFC1918-only auto-detect, proven VM
ownership, interface-scoped rules, config adds only), not an interface-wide
permit: direct public IPs the guest never resolved through ctrld stay blocked.
Tests cover rule generation and its interface scoping, the no-blanket-permit
boundary, single-family emission (no inet6 rule for an IPv4 source, IPv6 sources
skipped), a real pfctl -n -f parse of both the forwarded-source rules alone and
the full anchor (group-scoped rules stripped, since _ctrld exists only where the
service is installed), invalid/duplicate/non-IPv4 config entries, that a bad
entry does not fail config validation, the union set and its signature, a
deterministic guest start/stop lifecycle asserting both the rebuild points and
which subnets' states must be dropped, anchor-reload failure followed by a
successful retry, that reconcile is inert outside firewall mode, ifconfig member
parsing against real bridge output, and the trust decision per interface -
including everything that must NOT qualify: a Thunderbolt bridge, a
public-range VM bridge, an IPv6-only bridge, an address-less vendor interface, a
physical uplink and a VPN tunnel. docs/firewall-mode.md documents the boundary,
what auto-detection can and cannot prove, the address-family constraint, the
lifecycle/retry behavior, how to confirm the trust set from the log, and that a
resolver running inside the guest is not supported (its encrypted upstream
leaves the host nothing to allowlist).
Restore the previously merged macOS VPN DNS post-settle refresh,
unchanged-exemption suppression, forced pf state flush, and self-upgrade
test after they were removed by the firewall-mode merge.
Also keep Windows NRPT pointed at loopback when the listener is configured
on a wildcard address.
When WFP loopback protect is active, the upstream.os healthcheck will
always fail because an external WFP block filter is interfering with
plain DNS. This demotes those expected failures to debug level and
returns errOsHealthcheckSuppressed so the recovery loop treats them
as non-fatal, eliminating the log spam described in #526.
When third-party VPN software (e.g., OpenVPN) installs WFP block filters via
block-outside-dns, all DNS traffic to non-tunnel interfaces is blocked —
including DNS to 127.0.0.1 (ctrld's NRPT target). This breaks DNS mode
interception because the NRPT catch-all rule routes queries to loopback,
but WFP blocks the connection before it reaches ctrld's listener.
Fix: after exhausting all NRPT recovery attempts, activate a minimal WFP
session with "hard permit" filters (FWPM_FILTER_FLAG_CLEAR_ACTION_RIGHT)
for DNS to localhost in a max-priority sublayer (weight 0xFFFF). This
overrides the VPN's block for loopback DNS only, while preserving the
VPN's DNS leak protection for all other (non-loopback) DNS traffic.
The loopback protect is:
- Only activated when NRPT probes fail (not preemptively)
- Harmless when no conflicting WFP blocks exist (permit-only, no blocks)
- Persistent until ctrld shutdown (survives VPN reconnect cycles)
- Cleaned up by the existing cleanupWFPFilters path on shutdown
Cuong Manh Le